楼主:cao1jianxun 时间:2014-10-02 20:09

刚自己制作了一块PCB板,用的是ACTEL 的apa600,在仿真器FlashPro Lite连接FPGA的JTAG时候,无法烧写进程序,错误代码如下:
Software Version: 8.3.0.22
Driver : 2.0.4 build 3
programmer 'FPL31LPT1' : FlashPro Lite RevC
Opened 'D:\Actelprj\cy\fastnew\designer\impl1\dspboot_1_fp\dspboot_1.pro'
Rescanning for Programmers...
programmer 'FPL31LPT1' : FlashPro Lite RevC
Rescanning for Programmers DONE.
STAPL file 'D:\Actelprj\cy\fastnew\designer\impl1\dspboot.stp' has been loaded successfully.
DESIGN : dspboot;  CHECKSUM : 84D0;  ALG_VERSION : 22
programmer 'FPL31LPT1' : Scan Chain...
programmer 'FPL31LPT1' : Scan Chain PASSED.
programmer 'FPL31LPT1' : Executing action PROGRAM
programmer 'FPL31LPT1' : SERIAL# = 0C4011FFF07689
programmer 'FPL31LPT1' : Security enabled.
programmer 'FPL31LPT1' : Read inhibit: 1
programmer 'FPL31LPT1' : Write inhibit: 1
programmer 'FPL31LPT1' : Permanent Lock: 0
programmer 'FPL31LPT1' : Finished: Thu Oct 02 10:56:07 2014 (Elapsed time 00:00:00)
Error: programmer 'FPL31LPT1' : Executing action PROGRAM FAILED, EXIT 8, refer to User's Guide for details.

                        o - o - o - o - o - o


EXIT 8
this message occurs when the FPGA failed during the erase operation.
possible cases:
1. the device is secured ,and the corresponding STAPL file is not loaded .
2. the device has been permanently secured and can not be unlocked
solution: Load the correct STAPL file .
按照上面的意思好像是说FPGA被加密了,但是我是新的FPGA啊,而且是第一次烧写程序。本人刚刚学习FPGA还请各位不吝赐教。